Results 1 to 10 of 30

Thread: Installing a 3-prong attinuator?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. November 26th, 2012, 09:11 PM #22
    cradeldorf
    cradeldorf is offline
    Senior Hostboard Member cradeldorf's Avatar
    Join Date
    October 16th, 2010
    Location
    Muskegon Mi.
    Posts
    1,334
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    4 Post(s)

    Re: Installing a 3-prong attinuator?

    If you think your hard at understanding... If you could regale me as to which of the 3 prongs your using I would be most appreciative. Are you leaving out the ground wire then? Which wire goes where? And if done that way shouldn't it be before the crossover?
    Last edited by cradeldorf; November 26th, 2012 at 09:22 PM.
« Greetings from Toronto - New to Altec Model 19's | NEWBIE: OPEN BAFFLE solution - for Altec Duplex 604 E. »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

This forum has been viewed: 27889751 times.